After a heavy snowfall, a furnace can be running normally indoors while drifting or shoveled snow quietly builds up around its outdoor vent. For fuel-burning equipment, a blocked exhaust outlet can interfere with safe venting and increase the risk of carbon monoxide entering the home.
The safe response is simple: inspect accessible exterior vents during and after snowstorms, remove only loose snow with a soft brush or broom, and stop if you find solid ice, damage or anything you cannot identify confidently.
Why snow around a furnace vent matters
Health Canada advises homeowners to inspect exhaust vents during and after snowstorms because furnace, fireplace, dryer and other appliance outlets can be blocked by snow, ice or debris. Ontario’s Technical Standards and Safety Authority (TSSA) warns that blocked fuel-burning appliance vents can contribute to carbon-monoxide buildup inside a home.
Sidewall vent terminals may sit fairly close to the ground. In Schomberg, wind-driven drifts and snow moved by a shovel or snowblower can cover them faster than the open yard suggests.
What should you check after snowfall?
- From outdoors, visually check every accessible intake and exhaust terminal serving the furnace and other fuel-burning equipment.
- Look for loose snow, a drift built up against the wall, ice at the opening, sagging or cracked piping, and anything that appears displaced.
- Check the gas meter area for snow or ice accumulation without touching valves, regulators or gas piping.
- Make sure a snowblower or shovel has not pushed a new bank against the meter or vent pipes.
- Repeat the visual check during a long storm and after the storm ends.
If you do not know which exterior pipes belong to the heating system, do not guess or insert anything into an opening. A qualified technician can identify the terminals and explain what must remain clear for your particular equipment.
How to remove loose snow safely
TSSA recommends gently removing loose snow from gas meters and vent pipes with a car brush or broom. Work from stable ground and use light strokes so you do not damage the terminal or piping.
- Do not kick or strike a vent pipe or gas meter.
- Do not use a shovel, ice pick or other sharp tool against the equipment.
- Do not pour hot water on the meter or vent; refreezing can create more ice.
- Do not use an open flame, heat gun or electrical heater to melt ice.
- Do not remove caps, disconnect piping or reach inside a vent.
If ice is bonded to a vent or meter, a pipe looks damaged, or the area cannot be reached safely from the ground, stop and contact the appropriate utility or a qualified heating professional. Never climb onto an icy surface to reach a vent.
What if the furnace stops after a snowstorm?
A modern furnace may stop when its safety controls detect an unsafe operating condition. Do not repeatedly reset the system, bypass a safety control, remove equipment panels or attempt work on gas or electrical components.
From a safe position, you can note what the thermostat displays, whether other parts of the home have power and whether the exterior terminal is visibly clear. If the furnace still will not operate normally after loose snow has been cleared, arrange professional service.
Treat a carbon-monoxide alarm as an emergency
Carbon monoxide cannot be seen, smelled or tasted. If a CO alarm sounds, Health Canada says to leave the home immediately, move to fresh air, call 911 or local emergency services from outside, and return only after the problem has been fixed by a professional.
Do not search the home for the source. Headache, dizziness and nausea can be signs of exposure, but an alarm requires action even when nobody feels ill.
Ontario’s CO-alarm rules changed on January 1, 2026. Homes with a fuel-burning appliance, fireplace or attached garage require certified alarms on every storey and adjacent to each sleeping area. See our guide to Ontario carbon-monoxide alarm requirements for the details.
A practical winter routine
- Before the first major snowfall, identify the exterior vents and gas meter from the ground.
- Keep the snow-clearing path away from these locations.
- Check the area during and after each significant snowfall.
- Use only a soft brush or broom for loose snow.
- Call for help when you find ice, damage, repeated furnace shutdowns or anything uncertain.
When to call for heating service
If the vent is visibly clear but the furnace will not run normally, or if a vent pipe appears cracked, loose or displaced, the system needs qualified assessment. Do not operate equipment that may be venting incorrectly.
Review our heating service options and call Schomberg Heating & Cooling at (905) 939-2350. For time-sensitive service, call rather than relying on the website form.
